The operating system should automatically install the appropriate driver Foscam FI9828W IP Camera Firmware 2.x.1.118 to your Foscam device. If this has not happened, without a manual Foscam FI9828W IP Camera Firmware 2.x.1.118 driver installation your device may not work properly or may not use all of its features. Download the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver and install it on your computer - if the device still is not working properly, read the information further down the site about the Foscam device from the Digital Camera, Webcam category. There you will find helpful tips on how to install the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver. You will also learn why it is so important to have current Foscam drivers.
Operating System | / OS Independent | |
File size | 11.9 MB | |
Category: | Foscam • Digital Camera, Webcam | |
Number of downloads | 690 | |
Last update / Date added |
25.07.2014 |
After connecting a new Foscam device to your computer, the system should automatically install the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver. If this has not happened, you should take the following steps:
1. Check if the automatic update is enabled
It is the automatic update feature that is responsible for the installation of the Digital Camera, Webcam Foscam drivers on your computer. If the "UPDATE" feature was disabled, the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver could not be installed.
It is worth noting that in order for the automatic update to work, the computer must be connected to the Internet (perhaps when connecting the Foscam device the computer temporarily did not have the Internet connection or a WiFi signal was weak making it impossible to download the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver). To make sure, disconnect now and reconnect the Foscam device again, and maybe this time the driver will be downloaded.
2. Install the driver manually
This solution may seem more complicated - but it is nothing further from the truth. Just download the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver and start the installation (keeping in mind that the Foscam device must be at the same time connected to the computer). After the installation of the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver, the device should work properly.
It is very important that the Foscam devices connected to your computer had their current drivers installed. Without current Foscam FI9828W IP Camera Firmware 2.x.1.118 drivers there is a greater risk of the device malfunction, of the reduction in security, and there is a possibility of the total damage of the Foscam device. Manufacturers from time to time issue new versions of the Foscam FI9828W IP Camera Firmware 2.x.1.118 software, repairing the errors they find that may cause problems with the Foscam devices. Therefore, if you notice that a new version of the Foscam FI9828W IP Camera Firmware 2.x.1.118 driver is available, you should install it immediately.
Driver name | Driver details |
---|---|
12.4 MB / OS Independent |
|
12.4 MB / OS Independent |
|
2.7 MB / OS Independent |
|
2.7 MB / OS Independent |
|
2.7 MB / OS Independent |
|
Show all drivers by Digital Camera, Webcam Foscam |