The operating system should automatically install the appropriate driver Ralink RT2500 USB WLAN Card Driver 3.1.3.0 to your Ralink device. If this has not happened, without a manual Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver installation your device may not work properly or may not use all of its features. Download the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver and install it on your computer - if the device still is not working properly, read the information further down the site about the Ralink device from the Network Card category. There you will find helpful tips on how to install the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver. You will also learn why it is so important to have current Ralink drivers.
Operating System | / Windows Vista / Windows 7 / Windows 8 | |
File size | 129 KB | |
Category: | Ralink • Network Card | |
Number of downloads | 1405 | |
Last update / Date added |
25.07.2014 |
After connecting a new Ralink device to your computer, the system should automatically install the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver. If this has not happened, you should take the following steps:
1. Check if the automatic update is enabled
It is the automatic update feature that is responsible for the installation of the Network Card Ralink drivers on your computer. If the "UPDATE" feature was disabled, the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver could not be installed.
It is worth noting that in order for the automatic update to work, the computer must be connected to the Internet (perhaps when connecting the Ralink device the computer temporarily did not have the Internet connection or a WiFi signal was weak making it impossible to download the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver). To make sure, disconnect now and reconnect the Ralink device again, and maybe this time the driver will be downloaded.
2. Install the driver manually
This solution may seem more complicated - but it is nothing further from the truth. Just download the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver and start the installation (keeping in mind that the Ralink device must be at the same time connected to the computer). After the installation of the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver, the device should work properly.
It is very important that the Ralink devices connected to your computer had their current drivers installed. Without current Ralink RT2500 USB WLAN Card Driver 3.1.3.0 drivers there is a greater risk of the device malfunction, of the reduction in security, and there is a possibility of the total damage of the Ralink device. Manufacturers from time to time issue new versions of the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 software, repairing the errors they find that may cause problems with the Ralink devices. Therefore, if you notice that a new version of the Ralink RT2500 USB WLAN Card Driver 3.1.3.0 driver is available, you should install it immediately.
Driver name | Driver details |
---|---|
23 MB / Windows 8 64 bit |
|
18.3 MB / Windows 8.1 64 bit |
|
24.3 MB / Windows 8.1 64 bit |
|
21.9 MB / Windows 8 / Windows 8 64 bit |
|
18.3 MB / Windows 8.1 64 bit |
|
Show all drivers by Network Card Ralink |