The operating system should automatically install the appropriate driver AirLive N.Plug Wireless Repeater Firmware R1.04 to your AirLive device. If this has not happened, without a manual AirLive N.Plug Wireless Repeater Firmware R1.04 driver installation your device may not work properly or may not use all of its features. Download the AirLive N.Plug Wireless Repeater Firmware R1.04 driver and install it on your computer - if the device still is not working properly, read the information further down the site about the AirLive device from the Router, Switch, AP category. There you will find helpful tips on how to install the AirLive N.Plug Wireless Repeater Firmware R1.04 driver. You will also learn why it is so important to have current AirLive drivers.
Operating System | / OS Independent | |
File size | 2.6 MB | |
WWW | www.airlive.com | |
Category: | AirLive • Router, Switch, AP | |
Number of downloads | 1068 | |
Last update / Date added |
25.07.2014 |
After connecting a new AirLive device to your computer, the system should automatically install the AirLive N.Plug Wireless Repeater Firmware R1.04 driver. If this has not happened, you should take the following steps:
1. Check if the automatic update is enabled
It is the automatic update feature that is responsible for the installation of the Router, Switch, AP AirLive drivers on your computer. If the "UPDATE" feature was disabled, the AirLive N.Plug Wireless Repeater Firmware R1.04 driver could not be installed.
It is worth noting that in order for the automatic update to work, the computer must be connected to the Internet (perhaps when connecting the AirLive device the computer temporarily did not have the Internet connection or a WiFi signal was weak making it impossible to download the AirLive N.Plug Wireless Repeater Firmware R1.04 driver). To make sure, disconnect now and reconnect the AirLive device again, and maybe this time the driver will be downloaded.
2. Install the driver manually
This solution may seem more complicated - but it is nothing further from the truth. Just download the AirLive N.Plug Wireless Repeater Firmware R1.04 driver and start the installation (keeping in mind that the AirLive device must be at the same time connected to the computer). After the installation of the AirLive N.Plug Wireless Repeater Firmware R1.04 driver, the device should work properly.
It is very important that the AirLive devices connected to your computer had their current drivers installed. Without current AirLive N.Plug Wireless Repeater Firmware R1.04 drivers there is a greater risk of the device malfunction, of the reduction in security, and there is a possibility of the total damage of the AirLive device. Manufacturers from time to time issue new versions of the AirLive N.Plug Wireless Repeater Firmware R1.04 software, repairing the errors they find that may cause problems with the AirLive devices. Therefore, if you notice that a new version of the AirLive N.Plug Wireless Repeater Firmware R1.04 driver is available, you should install it immediately.
Driver name | Driver details |
---|---|
730 KB / OS Independent |
|
2.4 MB / OS Independent |
|
3.9 MB / OS Independent |
|
2.5 MB / OS Independent |
|
804 KB / OS Independent |
|
Show all drivers by Router, Switch, AP AirLive |